Introduction of XSG Series Zinc Oxide Spin Flash Dryer

The XSG Series Zinc Oxide Spin Flash Dryer is the new type dryer machine with patent; it was designed base on foreign advance technology, combined with the actual situation of domestic drying by ourselves.
The hot air be put into the flash dryer tower from the bottom of dryer body air inlet, it will be with the high speed air flow all rise in the dryer tower ,at the same time we can adjust the annular space
Depend on the different kind of materials, let the air speed goes in the best suitable state.
The material with High speed rotary motion under the impact of airflow and drive dispersed quickly. However the big size granulate and wet particular clusters cannot crush with high speed rotary motion, so it will fall into the crushing plant under the effect of gravity forcibly broken and particulates. and then with the high speed air flow going up and finish the drying process.
The rotor at the conical base of the drying chamber fluidizes product particles in a drying-efficient hot air flow pattern in which any wet lumps are rapidly disintegrated. Using the heat from the airstream, the material dries as it is conveyed. Product is separated using cyclones, and/or bag filters. Typically, cyclones are followed by scrubbers or bag filters for final cleaning of the exhaust gases to meet current emission requirements.
Airborne, fine particles pass through a classifier at the top of the drying chamber, while larger particles remain in the air flow for further drying and powdering

Feature of XSG Series Zinc Oxide Spin Flash Dryer

1.XSG Series Zinc Oxide Spin Flash Dryer Adopt 2 lines tangential air enter into volute at the best position,it will improve or remove blind Angle of wind and also the wind in the weak
2.Be good at control the powder's moisture,fineness,and hold time.for control the speed coordinating and unifying at spinning disk work with wind-enter ,it can ensure the outlet wind with low temperature,it will also reduce the energy consumption.
3. The special alloy steel be used in the rotary blade,the layout structure with unique,it have the character of small erosion,contact surface wide,cutting force strong.
4. Adopt the newly leak-proof structure,the main engine bearing life will be delay,and the bearing black with the cooling device.
5. In order to ensure the powder water content less than 0.5%,so increase the height than the original basis ,it also equip with spinning disk,it will make the powder quality and particle size meet with your requirement.
Due to the gas-solid corresponding relative velocity big,even though the mix temperature around 80~90℃,the powder temperature still on below 45℃ condition,it will help to packing and save energy.

Parameters of XSG Series Zinc Oxide Spin Flash Dryer

Picture of XSG Series Zinc Oxide Spin Flash Dryer